Resin 3D Printer Flex Building Plate Compatible with Anycubic Photon M3 Max/ M7 Max 3D Printer Accessories(309x172mm M7 max)

Conoce más detalles

Compatible with Anycubic Photon M3 Max/Compatible with Anycubic Photon M7 Max 3D PrinterResin 3D Printer Spring Steel Flexible Build Plate and Magnetic Base PlatformInstallation Notes:1.Please clean your build plate thoroughly, let it dry.2.Please connect your magnet to the plate, let it sit for a couple of hours(More than 24 hours is better)so it is fully seated.3.Please install the spring steel plate on the magnetic base4.Please reset the printer's leveling settings to start printingSkills in use:1.When installing the soft magnetic sheet, it is necessary to ensure that the printing platform is clean and dry. After installation, it is best to keep it in an inverted state, or it can be fixed with a clamp to ensure that the soft magnetic sheet is fully attached to the printing platform.2.Please ensure spring steel is completely aligned with the magnetic base to avoid the resin entering the gap during use, which will affect the magnetic force of the soft magnet and cause the spring steel plate to fall off.3.If there are burrs on the surface of the spring steel, please use sandpaper carefully to make sure that there are no burrs before using it to prevent the burrs on the spring steel from piercing the FEP film during the printing process.4.After printing, do not excessively bend the spring steel when removing the model. After use, use alcohol or cleaning fluid to remove the residual resin on the surface.5.After using for a period of time, if the model falls off the spring steel sheet during the printing process, you can sand the spring steel sheet with sandpaper to ensure that it has sufficient adhesion.3D printing platformIt is necessary to ensure that the printingplatform is clean and dry. After installation, itis best to keep it in an inverted state, or it canbe fixed with a clip to ensure that the softmagnetic sheet is completely attached to theprinting platform.Soft magnetic boardTo prevent resin from entering the gap duringuse, first ensure that the spring steel and themagnetic base are completely aligned, so asnot to affect the soft magnetic force and causethe spring steel to fall off during use.Steel boardAfter the soft magnet is connected to the board, it is recommended to leave it for a few hours (more than 12 hours is better) to make it completely fixed.Model Number :Compatible with Anycubic Photon M3 Max 3D Printer 310x174mmItem Type : Resin 3D Printer Flex Building Plate